Using Active Thermography defects such as cracks can be detected fast and reliably. Choosing from a wide range of excitation techniques the method can be adapted to a number of tasks in non-destructive evaluation. Induction thermography is ideally suited for testing metallic components for cracks at or close to the surface. In power generation a number of components are subjected to high loads and stresses-therefore defect detection is crucial for a safe operation of the engines. Apart from combustion turbines this also applies to generators: At regular inspection intervals even small cracks have to be detected to avoid crack growth and consequently failure of the component. As an imaging technique thermography allows for a fast 100% testing of the complete surface of all relevant parts. An automated setup increases the cost effectiveness of induction thermography significantly. Time needed to test a single part is reduced, the number of tested parts per shift is increased, and cost for testing is reduced significantly. In addition, automation guarantees a reliable testing procedure which detects all critical defects. We present how non-destructive testing can be automated using as an example an industrial application at the Siemens sector Energy, and a new induction thermography setup for generator components.